Klantbeoordelingen voor VEVOR 5" Freesmachine Vergrendeling Bankschroef Draaibare Basis Acme-schroeven 360 Graden 24KN

Mooi verpakt en voldoet volledig aan de verwachtingen, zeker voor die prijs!! Alle nagemeten vlakken zijn mooi binnen tolerantie en de klem was direct bruikbaar zonder extra aanpaswerk.

For the money it's an excellent vice. The keys need to be machined to suit the machine it is to be used on, but no big deal. Very pleased so far.

Uitstekende kwaliteit en zeer snelle levering. Prijs kwaliteit verhouding is prima. Echt een aanrader.

Does what it says on the tin. Needed a quick once over with a needle file for a bit of deburring, but at this price there is nothing to complain about.

Voor de prijs is het een mooi grote maschieneklem, zeer accuraat en als je het sluit zie je de naad niet eens. Bij aflevering kwam snel achter dat het behoorlijk groot was en terugsturen was geen optie, gelijk de 3” variant besteld..

All surfaces within 25 microns. Only fault was brass bush on leadscrew not drilled through for oil feed. Oiler above it was therefore a waste of space! Drilled out bush and now very happy with vice!

Degelijk, ziet er goede kwaliteit uit. Klauwen schuiven soepel weinig speling Bij veelvuldig gebruik zal het uitwijzen dat het top is.

This is the fourth item I have purchased from vervor and I am very happy with all of them, the vice was bought for my shaper and it works well does not slip or move when in use, I also have the larger 100mm vice on my mill, also happy with its clamping power and accuracy.

Very pleased with my purchase. These two smaller vices complement a larger one. I was expecting to see the coolant drain, but this rotating model is perhaps too small for that.

It's cheap and cheerful, for the money it's bloody good, I ran a dti over it and it was within 0.01mm on X,Y&Z. edges needed easing as many youtube reviews have said, The base was pretty good I ran a stone over it and although not absolutely perfect I wasn't concerned about anything. The jaws I will probably replace as when the vice arrived they were ground flat on the top, I assume once assembled. once taken apart there is no repeatability. I had to jiggle them about a bit to get them back trammed with the dti. but hey ho it's not a Kurt and not a Kurt price. I can't really comment on the swivel base as I only checked for parallelism. for the deg if I wanted accuracy I would use a sine bar anyway. One thing I did notice was 0 deg started underneath the screw, making 90 deg to the side where there is a mark for setting, no problem for me though. I have the vice on the bed with no base, used my own T nuts and bolts as they were better. For the money it is very good value in my opinion, and would not hesitate in purchasing another should the need arise .